ADJ UBL9H not working with the WMX1 controller

[axell]

welll, do not "confuse" yourself.
take ONE product at a time - either EasyView2 Virtualization ..OR.. Wolfmix (attached with REAL fixtures).

I am ONLY do WOLFMIX - so forget EasyView2 for a moment.

Starting over again:
Once you uploaded the (new) profile -UBL9H (6ch+18ch).ssl2- into the Cloud, you switch to WTOOLS (on Computer) and sync this file from the WTOOLS / FIXTURE / Cloud folder into the WOLFMIX controller Cloud folder - NOT(!!) the ADJ UBL9H ....make sure the modified profile with (6ch+18ch) extension in the name could be seen in the CLOUD folder.

Once you copied this file to the WOLFMIX, you CONTINUE on WOLFMIX now:
push HOME button (on Wolfmix)
now push FIXTURE button (on Wolfmix), and then FIXTURE (+) button (on Wolfmix) , to add a fixture to your project.
Now navigate on the left to the Cloud folder and select the UBL9H (6ch+18ch) profile.
Select the channel Mode (either 6ch or 18ch) and load it.
Finally make sure your UBL9H light is set to use the same channel mode as you loaded and your DMX Start address is identical on the light and on Wolfmix as indicated in the Fixture setup screen (on Wolfmix) on the right.

If you STILL have problems, we may need to talk (need your contacts)

[Brian]

Hi Axell, I believe I have got it now. I did everything you said, and the light is hooked up to my WMX1 Controller and is working according to the commands I give it. There is no whitish light. Thank You so very much again for all your effort. My last question is: When I want to add this fixture again to other programs, do I have to go to the Cloud Fixture file on the Controller, or can I add this to the ADJ File?

[axell]

No - the ADJ folder is holding the "faulty" profile. You will continue to use the "modified" profile which is in the CLOUD folder (with the longer name (6ch+18ch). Because THAT now is optimized to work on Wolfmix.