Wolfmix

goed day everybody
i have a china copy multi bar that looks like the chauvet gigbar but the dmx isnt the same. i have build my own fixture in fixture builder and asingd multiple beams
2xmovinghead beam 1 and 4
2x par beam 2 and 3
2xderby beam 6 and 7
strobe leds beam 5

now is the question when i load a original chavet gigbar you get the question in the wolfmix this fixture has more than one beam woold you like to split the fixtur.
with the fixture i have build i dont get the question and than i dont get the possibility to plit in the groeps movingheads,derby,par and stroboscoop

is there sombody that can tell me where to look?

in order to make a profile to "split" you need to assign "beams" to the "functional groups".
These "beams have to be in strict SEQUENTIAL order (from 1 - to - 7 ...and not 1; 4; 2; 3; ..!)
Also the profile does not allow channels with "multiple" beam assignments or "all beams" - then the profile cannot be split and just loads as a single fixture (unable to split into functional groups for individual Group control)

Thanks for your repli
I Will look if I can chance that and that wil fix it

i am getting close

changed everything to what you told me.
now i get the question this fixture has more than one beam !
a have asinged them to groops
A movingheads.
B Parren
C Derby
D stroboscoop.

but channel 1 was the dimmer for all beams and now i dont get any light ?

(ps sorry for the bad english)

Replace Dimmer on Ch1 with Channel Type OTHER and one Preset "OTHER" with a default DMX value 255.
Set THIS channel again to beam1 - so it will "always be ON"

Thanxs i will try this