china copy like the chauvet gigbar ils

Fixture not working as it should? Post it here and we'll check it out. Be precise with the fixture name as there are many with similar names.
edbroeren
Posts: 4
Joined: Mon May 20, 2024 9:38 am

china copy like the chauvet gigbar ils

Post by edbroeren »

goed day everybody
i have a china copy multi bar that looks like the chauvet gigbar but the dmx isnt the same. i have build my own fixture in fixture builder and asingd multiple beams
2xmovinghead beam 1 and 4
2x par beam 2 and 3
2xderby beam 6 and 7
strobe leds beam 5

now is the question when i load a original chavet gigbar you get the question in the wolfmix this fixture has more than one beam woold you like to split the fixtur.
with the fixture i have build i dont get the question and than i dont get the possibility to plit in the groeps movingheads,derby,par and stroboscoop

is there sombody that can tell me where to look?
axell
Posts: 376
Joined: Sat Feb 12, 2022 8:52 am

Re: china copy like the chauvet gigbar ils

Post by axell »

in order to make a profile to "split" you need to assign "beams" to the "functional groups".
These "beams have to be in strict SEQUENTIAL order (from 1 - to - 7 ...and not 1; 4; 2; 3; ..!)
Also the profile does not allow channels with "multiple" beam assignments or "all beams" - then the profile cannot be split and just loads as a single fixture (unable to split into functional groups for individual Group control)
edbroeren
Posts: 4
Joined: Mon May 20, 2024 9:38 am

Re: china copy like the chauvet gigbar ils

Post by edbroeren »

Thanks for your repli
I Will look if I can chance that and that wil fix it 👌
edbroeren
Posts: 4
Joined: Mon May 20, 2024 9:38 am

Re: china copy like the chauvet gigbar ils

Post by edbroeren »

i am getting close

changed everything to what you told me.
now i get the question this fixture has more than one beam !
a have asinged them to groops
A movingheads.
B Parren
C Derby
D stroboscoop.

but channel 1 was the dimmer for all beams and now i dont get any light ?

(ps sorry for the bad english)
axell
Posts: 376
Joined: Sat Feb 12, 2022 8:52 am

Re: china copy like the chauvet gigbar ils

Post by axell »

Replace Dimmer on Ch1 with Channel Type OTHER and one Preset "OTHER" with a default DMX value 255.
Set THIS channel again to beam1 - so it will "always be ON"
edbroeren
Posts: 4
Joined: Mon May 20, 2024 9:38 am

Re: china copy like the chauvet gigbar ils

Post by edbroeren »

Thanxs i will try this👌
Post Reply