Position programming bug

[BarryV]

WMX1 v2 running 2.0.4 firmware
I'm not sure if this bug has been posted.
I'm setting up some positions in the Position window. I have been copying one position to the next to make adjustments and then save the new position. When I Shift+click on Group C-position 13 to highlight it and then click on Group C-position 14 to copy it - as soon as I click on 14 the WMX locks up and the LCD window goes dark. (The fixture is a V-show 7x40)
I've been creating various positions and copy/pasting on Groups A-D and so far up to positions 13, this is the only bug I've found so far while doing that.

Specific to Group C position 14 and I can repeat it. And it happens when copying from any other position button to Group C-position 14

Thanks
Barry

[axell]

I can not duplicate your problem. I do exactly as you said:
SHIFT/click Position 13, then editing a few values and restore Position 13. Then SHIFT/click Position 13 again (copy), then SHIFT/click Position 14 (paste) and push again (confirm). No reboot, just a normal copy/paste of the values from Position 13 to Position 14 now ...
(something else ongoing in your "project"?)