WMX1 control of the Chauvet Gigbar Move+ ILS discussion

[ScottB]

Great job Tarekith… thanks for putting that together. Hope your show over the weekend went well.

[Tarekith]

If anyone runs across this thread in the future, Chauvet finally updated the manual with the correct DMX addresses, as well as the DMX values and examples for all the laser patterns:

https://www.chauvetdj.com/wp-content/up ... _Rev11.pdf

[nanosukkai]

Hi,

Thank you for sharing the show however I have the EU version in 52ch and the US version 51 according to the manual you shared.
My moving heads and the laser are not working properly. The laser uses 3 channels compared to 2 on the US version
I cannot modify the fixture on the woflmix because it is a show import via wtools. Any solution please for my case? Thanks in advance.

https://fr.chauvetdj.com/wp-content/upl ... _Rev13.pdf

[Tarekith]

You will need to set up your own profile from scratch then so all the channels match up with the EU version.

[nanosukkai]

Thank you for your feedback, I started from scratch with the EU version.