fazer

[pieterl]

Hi
I just added a Beams F1600 fazer with the existing user profile.
Have not connected the device yet, but was just checking the setup.

I'm checking the dmx values.
The 'smoke' channel is at dmx value 127 by default - is that correct?

[axell]

You may have used the "old" Profile which is not reflecting the newer Wolfmix capabilities for 2Ch Hazer support (firmware 0.6.1+.)

Download the profile I have attached.

You can pre-select the Fan Speed and the Fazer amount when you press (SHIFT) + SMOKE button. The first 2 columns on the left gives you 5 ranges (1%, 25%, 50%, 75, 100%) for Fazer amount and Fan speed. The most right column defines whether the SMOKE button acts like a FLASH button or on/off toggle and 3 hold time presets (1 sec; 5 sec; 10 sec).

[pieterl]

Thank you.
I now use this profile but when I check the dmx values, by default the smoke channel is at 127 again.
That's not what it should be, right?
I believe I've got the same issue with a strobe which has is blinder on by default too.
Why aren't these channels not just at 0?

[axell]

checking the profile again and there is no reason why Ch 1 shows 127 as default. In my tests both channels (1+2) jump back to 0 when switching off Smoke button.
Channel 1 has even a dedicated Preset 1 with values 000-000 as default. So it defaults to this Preset (which has avalue of 0)
Is there maybe a Live Edit Preset active which „overrides“ the Channel 1 of the Fazer?