Wolfmix

Hi There !

i have some issues with the fixture CAMEOCLPSTTRI12IP.

i can't use the 3CHANNEL MOD1 and the 6CHANNEL Mode.

Only the 3channel mode 2 works.

Could you please help me ?

Thanks a lot.

Max.

I am sure you have your reasons why you are in "need" of 3Ch Mode 1 and 6Ch mode.

You prefer to have 7 fixed(!) colors only over possible 16 Mio Colors just using RGB (3ch Mode 2) and also want Color Change / Color blend of these 7 Colors as an automated (fixture only) function (without further Wolfmix control). ColorChange/Color blend (of 16 Mio colors) is what Wolfmix normally is doing.

6 Channel Mode does not make much sense here, as you EITHER use the 7 fixed Colors (and invalidate the RGB channels for that) - OR - you use the RGB channels (and then have to invalidate the 7 fixed Colors + Color Change/Blend for that). So you anyway end up with 3 channels of control - either this or that way. You can't have both at the same time (RGB + fixed Colors). This mode was made by Cameo for compatibility reasons if someone is using a controller not supporting individual RGB channels - so it default to a Color Wheel mechanism using 7 Colors. Wolfmix does all that, so the 3Ch Mode-2 (RGB) is all you need. (.. and Dimmer and Strobe is provided automatically to just these 3 channels by Wolfmix itself).

Profiles can be created by yourself either using the built-in Profile Builder (Editor) inside Wolfmix or conveniently on the Cloud Profile Builder (cloud.nicolaudiegroup.com)
(attached is a 3Ch Mode 1 and a 6Ch mode profile ...)