Easy View Connect
Posted: Thu Oct 03, 2024 1:14 pm
Easy View Connect does not recognize the Wolfmix hardware. The Wolfmix's firmware is 1.2.2.Under 1.2.1. everything went perfectly. Does anyone have the same problem?
Hope that helps!
Page 1 of 1
Re: Easy View Connect
Posted: Thu Oct 03, 2024 3:13 pm
Please try to restart your PC/Mac and also Wolfmix, then start WTOOLS and try again.
Hope that helps!
Hope that helps!
Re: Easy View Connect
Posted: Fri Oct 04, 2024 2:05 pm
The "start sequence" of EasyView2 is important!
set toggle switch in WTOOLS first to OFF position
Start EasyView Connect via link
Once the empty virtualization window appears - now switch the toggle switch in WTOOLS to ON
There is NO automatic import of the Wolfmix project into the EasyView2 project! You have to patch the EasyView project from scratch again. Wolfmix is ONLY acting as the "DMX Controller" for EasyView2
set toggle switch in WTOOLS first to OFF position
Start EasyView Connect via link
Once the empty virtualization window appears - now switch the toggle switch in WTOOLS to ON
There is NO automatic import of the Wolfmix project into the EasyView2 project! You have to patch the EasyView project from scratch again. Wolfmix is ONLY acting as the "DMX Controller" for EasyView2
Re: Easy View Connect
Posted: Sat Oct 05, 2024 11:57 am
Thanks for the help, there was also a Mac OS update in between, I don't know if that was the solution. Anyway, it works again.