Wolfmix

Hi,

Good morning,

My computer being H.S, I cannot create the Beam 8x12W RGBW LED bar fixture, so I am writing to you from my mobile.

Is it possible to create the fixture in 38ch and 9ch?

Thanks in advance !

Sincerely, Patrick - SC

If using9Ch mode you have the same color on all LEDs.
When using the 38Ch mode you can have different colors on different LEDS when turning up the PHASE encoder in ColorFX. At 0% you have the same colors on all LEDS (like in 9Ch mode). If you crank up the PHASE encoder you will notice more and more different colors show up on the LEDs.

(just make sure you setup the LED Bar with the same Channel Mode as the one you load into Wolfmix Mode 1 = 9Ch / Mode 2 = 38Ch)

Thank you very much Axell !

I also prefer the much more complete 38ch mode, with more possibilities for color combinations!