Wolfmix

The deposited profiles

KLS Laser Bar FX
LED KLS Laser Bar Pro

are not recognised and divided by the Wolfmix as Multi Bar.

The profile LED KLS Laser Bar Pro FX is recognised and split as desired.

How should the control of the rotation of the derby's and the laser work? only via Live Edit?

A direct division into groups would be nice, as not all fixtures support all functions. (for example laser no ColorFX)

Fixture 1 (Derby 1) - Group A
Fixture 2 (Spot 1) - Group B
Fixture 3 (Spot 2) - Group B
Fixture 4 (Derby 2) - Group A
Fixture 5 (Laser) - Group C
Fixture 6 (Strobe 1) - Group D
Fixture 7 (Strobe 2) - Group D
Fixture 8 (Strobe 3) - Group D
Fixture 9 (Strobe 4) - Group D
Fixture 10 (Strobe 5) - Group E (UV Lamp)

With this group division it works great

and a clear improvement over Light Rider, now all the functions of the Multi Bar can finally be used. Great job!!!

I actually went out and bought a Eurolite KLS Laser Bar Pro FX to be sure it worked properly, and used this during development. I use the same group assignments you suggested.

I've just been through the other variations of this profile mentioned and corrected some of the beam assignments. Let me know if it solves the problems.

Hello Simon,

Thanks for the feedback, I will test the other profiles.

How should the control of the rotation of the derby's and the laser work? only via Live Edit?

Yeah it's what I used

I've just been through the other variations of this profile mentioned and corrected some of the beam assignments. Let me know if it solves the problems.

The profiles are now recognised as multi-bars by wolfmix. WWW status is fulfilled.