Position programming bug
Posted: Thu Jul 03, 2025 9:50 pm
WMX1 v2 running 2.0.4 firmware
I'm not sure if this bug has been posted.
I'm setting up some positions in the Position window. I have been copying one position to the next to make adjustments and then save the new position. When I Shift+click on Group C-position 13 to highlight it and then click on Group C-position 14 to copy it - as soon as I click on 14 the WMX locks up and the LCD window goes dark. I have to power cycle to reboot. (The fixture is a V-show 7x40 if it matters)
I've been creating various positions and copy/pasting on Groups A-D and so far up to positions 13, this is the only bug I've found while doing that.
Specific to Group C position 14 and I can repeat it. And it happens when copying from any other position button to Group C-position 14
Thanks
Barry
I'm not sure if this bug has been posted.
I'm setting up some positions in the Position window. I have been copying one position to the next to make adjustments and then save the new position. When I Shift+click on Group C-position 13 to highlight it and then click on Group C-position 14 to copy it - as soon as I click on 14 the WMX locks up and the LCD window goes dark. I have to power cycle to reboot. (The fixture is a V-show 7x40 if it matters)
I've been creating various positions and copy/pasting on Groups A-D and so far up to positions 13, this is the only bug I've found while doing that.
Specific to Group C position 14 and I can repeat it. And it happens when copying from any other position button to Group C-position 14
Thanks
Barry