Page 1 of 1
Wondering if others have this same issue -- Speed function not working when triggering it via MIDI ?
Posted: Wed Jun 18, 2025 9:58 pm
by Wolfman_Malone
I have an Akai APC Mini mk2 and I have Speed set to a pad. When I trigger it on the Wolfmix it works normally (And the Akai lights up as it notices the effect is being triggered). But when I trigger it on my Akai, the Speed effect does not happen. The pad lights up, and even my Wolfmix Speed button lights up, but still, no Speed effect gets triggered.
I've submitted this via support ticket along with a video of it a month ago so I know they are working on it. But, I am just curious if anybody else is also experiencing this?
Re: Wondering if others have this same issue -- Speed function not working when triggering it via MIDI ?
Posted: Thu Jun 19, 2025 3:43 am
by BarryV
Wolfman
I wasn't planning on using my APC mini to control the flash buttons, but I just mapped them to the right side column of buttons to see what happens. Those are Note 112 - 119. The ADJ/Wolf function and Blackout are the only two that work for me. Strobe, Blinder, Speed, Smoke don't respond on the APC, while still working on the WMX.
Hoope that helps
Barry
Re: Wondering if others have this same issue -- Speed function not working when triggering it via MIDI ?
Posted: Thu Jun 19, 2025 7:17 am
by willm
Hello!
Thanks for raising this thread. I am able to reproduce the initially reported issue (Speed function not being triggered through MIDI). This has been reported to the devs to look into.
@Barry - I am not able to reproduce your report however (besides of course the Speed function). Does this also apply in a new/empty project file, or only in an existing project?
Re: Wondering if others have this same issue -- Speed function not working when triggering it via MIDI ?
Posted: Sat Jun 21, 2025 8:23 am
by BarryV
willm wrote: ↑Thu Jun 19, 2025 7:17 am
Hello!
Thanks for raising this thread. I am able to reproduce the initially reported issue (Speed function not being triggered through MIDI). This has been reported to the devs to look into.
@Barry - I am not able to reproduce your report however (besides of course the Speed function). Does this also apply in a new/empty project file, or only in an existing project?
Will
Thanks for looking into that. Using 2.0.4 I created a new test project with a SHehds spot fixture on group A and mapped a couple presets to the APC mini. Also mapped the flash buttons to MIDI 112-116 pads. In the new project, the midi buttons (except Speed) all work to control the WMX Flash buttons. My main project file and a couple others were created from scratch in 2.0.4. I'm not sure why there would be a difference.
Barry