Wolfmix

Hi,

I'm having an issue with my 6-channel 2-eye blinder. I want to set a specific color temperature using a locked live edit. The problem is: when I set the two color channels to specific values, the dimmer channel is also affected — even though it shouldn't be.

Do you have a solution for this?

I tested it with the previous 1.x software version, and everything worked fine there. So it might be an issue with the new firmware version 2.4. Interestingly, in the DMX output value screen, the dimmer channel still shows as 0 — but it's actually being sent out.

not without sufficient information:

What fixture model (name!) are you using (6ch 2-eye blinder is not very precise)?
What profile did you load for it (name)?
What is your Live Edit looks like (either describe or do a pic and upload)?
(eventually touched Dimmer channel - and accidentially set to 0 which has been stored with) ...