Is there any way to adjust how long Color and Beat FX will continue to run between beats detected by microphone or line-in? It seems like there was a change in how this is handled between 1.1.8 and 1.2.4. (I often delay updating firmware in production environments)
For example, In 1.1.8 and earlier, if I had the Wave pattern selected in Beam FX and Rainbow in Color FX, the pattern would continue to run for a few seconds before eventually fading out if a beat wasn't detected for a while. But in 1.2.4 the pattern will simply freeze after about 0.7 seconds without a beat. Same with Color FX twinkle pattern and others.
I had previously leveraged that quirk of the Wolfmix effects engine and would love to find a way to replicate it again.