Page 5 of 5
Re: WMX1 control of the Chauvet Gigbar Move+ ILS discussion
Posted: Thu Nov 09, 2023 2:20 am
by ScottB
Great job Tarekith… thanks for putting that together. Hope your show over the weekend went well.
Re: WMX1 control of the Chauvet Gigbar Move+ ILS discussion
Posted: Mon Jan 29, 2024 1:52 am
by Tarekith
If anyone runs across this thread in the future, Chauvet finally updated the manual with the correct DMX addresses, as well as the DMX values and examples for all the laser patterns:
https://www.chauvetdj.com/wp-content/up ... _Rev11.pdf
Re: WMX1 control of the Chauvet Gigbar Move+ ILS discussion
Posted: Wed Jul 10, 2024 6:59 pm
by nanosukkai
Hi,
Thank you for sharing the show however I have the EU version in 52ch and the US version 51 according to the manual you shared.
My moving heads and the laser are not working properly. The laser uses 3 channels compared to 2 on the US version
I cannot modify the fixture on the woflmix because it is a show import via wtools. Any solution please for my case? Thanks in advance.
https://fr.chauvetdj.com/wp-content/upl ... _Rev13.pdf
Re: WMX1 control of the Chauvet Gigbar Move+ ILS discussion
Posted: Sat Jul 13, 2024 2:16 pm
by Tarekith
You will need to set up your own profile from scratch then so all the channels match up with the EU version.
Re: WMX1 control of the Chauvet Gigbar Move+ ILS discussion
Posted: Sun Jul 14, 2024 1:10 pm
by nanosukkai
Thank you for your feedback, I started from scratch with the EU version.