Hello,
Do you think I've configured my light correctly?
I've encoded each type of light on this model into a Beam.
see my picture in attachment
Lyre 360_page 2_2025-06-17_16-26-09_2.jpg (222.79 KiB) Viewed 132 times
Lyre 360_2025-05-26_14-55-27_2.jpg (468.74 KiB) Viewed 132 times
2025-06-18_19-10-10_2.jpg (277.14 KiB) Viewed 132 times
but if a want use Move FX with PAN (horizontal) i have i very very very small left-right
How do I enlarge the pan horizon, knowing that I've correctly set the minimum DMX channel limits to 0 and the maximum to 255?
Same thing for the MOVE FX with the Tilt (vertical); I only have a tiny, barely visible movement...
Thanks for help me.
Last edited by martel on Thu Jun 19, 2025 8:33 am, edited 1 time in total.
From what I can see- the profile looks to be set up totally fine, I personally can't see any adjustments that would need to be made. Is your Move FX size parameter set low? If you set it to 100%, does the movement range improve?
If you disable your Move FX, then go to Live Edits, then create a new button and start sending a DMX value to the Pan channel (change from 0 - 255)- do you see the expected range of movement? If you do the same for your Tilt channel- do you see the expected range of movement? If not- there might be a setting on the physical fixture that you need to adjust. The user manual states that there should be a Pan range of 540 degrees, and a Tilt range of 320 degrees- however some fixtures allow you to set a restricted movement range using the in built settings.
If you disable your Move FX, then go to Live Edits, then create a new button and start sending a DMX value to the Pan channel (change from 0 - 255)- do you see the expected range of movement? If you do the same for your Tilt channel- do you see the expected range of movement? If not- there might be a setting on the physical fixture that you need to adjust. The user manual states that there should be a Pan range of 540 degrees, and a Tilt range of 320 degrees- however some fixtures allow you to set a restricted movement range using the in built settings.
yes when use the Live Edits, and send value into Pan channel 0 to 255 the movement is good, it is turn completly. and the same for Tilt.
But i dont understand where the Button Move FX with Pan (icone <-> ) find the value min and max, for me i see in right bottom min 0 and max 255
