LED Bar Beams Bug

[Yoshi]

Hello everyone,

I have some "PURElight PixelBar Switch 224 x SMD RGB" bars.

These offer 16 RGB blocks.

Unfortunately, the order is a bit badly positioned:

When the bar is placed vertically, placement proceeds as follows:

Bottom left is block 1, top left is block 8.
Bottom right is block 9 and top right is block 16.

This means that if I numbered the beams from 1-16, the chaser would not look good, for example.

The workaround is to assign Block 1 - Beam 1. Block 2 - Beam 3... etc.

It would be desirable if I could use block 1 and block 9 (bottom left and bottom right) as beam 1.

Unfortunately, I have the bug that if I assign beam 1 to block 1 and block 9, then block 9 on the bottom right is approached and output in 100%.

Can someone tell me why that is?

Thanks!

[axell]

redo the profile and configure from 16 beam to be a 8 beam profile.
Now assign the first 8 RGB segments (1-8) to beams 1-8. And then assign next 8 RGB segments (9-16) again to beams 1-8. You That way you have no "beam 9 -16" any more