i have a classic RGBW par with 5 channels
1: Dimmer 0-255
2: Red 0-255
3: Green 0-255
4: Blue 0-255
5: White 0-255
i want to use it as strobo and blinder.
my problem is:
to use it only as strobo i have to set DIMMER to 100% full white (example on Group A with this PAR only inside) . Then i press STROBE button and all works... the par.. strobe good!
Problem is when i want to stop the strobe and have if OFF. if u press again the strobe button the par become a blinder! 100% full ON white blinder. there is a workaround ? i just want it this way:
blinder OFF > PAR LIGHT OFF
blinder ON > PAR LIGHT ON AND STROBE
Second question.... while the strobe is ON and i press the blinder button... the blinder.. doesnt work. it has no priority over strobe but act like a "color change". example, if u have a BLUE strobing fixture then u press BLIND, the fixture light color change to white but... its still strobing so... the blinder does work as a blinder with strobe ON.
any workaround here too?
thanks