Cameo Instant Hazer 1500 T Pro

[fohlwilting]

Hey there,

the Cameo Instant Hazer 1500 T Pro has two channels: Smoke and Smoke Fan
https://www.cameolight.com/de/downloads ... 1096330246

So when a fixture profile has two channels, one where smoke off is at zero and smoke is set from 1 to 255 and the second channel the smoke fan is set to 0 means off and smoke fan from 1 to 255, shouldn't it be controlled via the smoke button? At the moment the fan works. I can press the smoke button and adjust the fan with the second encoder. But the first one doesn't change anything. What do I miss? Or is it the specific fixture preset?

Thanks and greetings
Lars

[axell]

You only need a correct profile for best 2Ch operations.Both channels need to be configured as "SMOKE" channels, where one channel is SMOKE AMOUNT and the other channel s SMOKE FAN - see attached 2Ch profile for Instant Hazer 1500 T Pro.

You can pre-select the Fan Speed and the „Fog" amount when you press (SHIFT) + Smoke button simultaneous. The first 2 columns on the left gives you 5 ranges (1%, 25%, 50%, 75, 100%) for (Fog) Intensity and Fan Speed. The column on the right defines whether the SMOKE button acts like a flash button or on/off toggle. The other 3 buttons are timer presets with various hold times (1 sec; 5 sec; 10 sec). So when press the SMOKE button it uses the pre-defined settings