Wolfmix

the change from toggle to flash was the ONLY variation of color you could have (from "peach" to "blue") on the older firmware. With the newer firmware you have much more colors now to select from when you want to change the color of the Preset button (regardless if it is toggle o...

you may want to enable the FLASH function on those Presets, which have been "blue-ish" instead of "peach" "Peach" indicates toggle function (On/Off), "Blue" is for "FLASH" functions (temporary) To get there you want to hold SHIFT and select the Prese...

sorry, my fault, overseen the wireless issue, thought it was a general malfunction of the RGBW Strobe fixture ...

You can do store Presets without active Colors. But you can NOT "stack up" Presets! So it won't help you to run one Preset and then "add" different Colors to it. Presets on Wolfmix are different and NOT just describing a Color or function and that being stored. A Preset - EVERY P...

misinterpreting the question - answer is not relevant to original question...

Are these fixtures exhibiting uncharacteristic behavior due to a firmware issue, or could there be another underlying cause for their erratic performance? Wolfmix is running perfect. Your fixture(s) most likely running perfect too. What is NOT optimized is the "glue" between the Wolfmix c...

Shane to solve your problem with Octostrip, I would suggest the following: 1. decide what Channel Mode you want to use. Wolfmix has a max of 1.024 adresses (4 universes x 512Ch) - so that is your max limit. If you want to use 208Ch mode (100cm) or 206Ch (50cm) - then you can only connect up to 4 Bar...

You do not ADD the Modes for the max Channel counts, as you only load ONE Mode at a time - THIS then defines the channel count. But it is true that those fixtures with high multiple functions (12x Tilt, 12x Zoom, 12x RGBW) the profiles need special attention and they are not ready out-of-the-box to ...

1. You have (and want) to have certain fixtures in different GROUPS (A;B;C;D....H), so you can put different Colors on 2. You even can apply 2 or more Colors on ONE GROUP of fixtures: In STATIC COLOR (NOT! ColorFX!!) - dial the Group rotary encoder from SINGLE to "ALTERNATE" (dot on/off/on...

Not the letters itself. But you can add a word or short description like Moving Heads or Floors and such. To do that: Select HOME / SETUP / GROUPS. Select the Group you want to edit (highlight orange) and then click on the "cursor/letter" icon in the upper right hand corner to open the Key...