Search found 4 matches
- Wed Dec 13, 2023 11:56 pm
- Forum: Wolfmix Owners Forum
- Topic: Can you remote control a wolfmix
- Replies: 4
- Views: 3451
Re: Can you remote control a wolfmix
I've encountered this scenario before. My solution was using battery-powered wireless DMX dongles and a USB power bank. I plugged a Chauvet D-Fi XLR RX receiver at the start my DMX chain (or at the start of the DMX cable at the usual mixing desk spot), and plugged a Chauvet D-Fi XLR TX in the back o...
- Wed Dec 13, 2023 11:38 pm
- Forum: Wolfmix Owners Forum
- Topic: FIRMWARE BUG? Line-in beat detection not working in WLINK mode v1.1.8 [RESOLVED]
- Replies: 2
- Views: 2691
Re: FIRMWARE BUG? Line-in beat detection not working in WLINK mode v1.1.8 [RESOLVED]
Thank you axell!
As a follow-up, I strangely was not able to reproduce the bug after re-testing, so I'm leaving firmware as-is for now and have updated the original post accordingly.
As a follow-up, I strangely was not able to reproduce the bug after re-testing, so I'm leaving firmware as-is for now and have updated the original post accordingly.
- Tue Dec 12, 2023 2:46 pm
- Forum: Wolfmix Owners Forum
- Topic: FIRMWARE BUG? Line-in beat detection not working in WLINK mode v1.1.8 [RESOLVED]
- Replies: 2
- Views: 2691
FIRMWARE BUG? Line-in beat detection not working in WLINK mode v1.1.8 [RESOLVED]
EDIT: After further investigation, it appears to have been a one-off fluke that I have not been able to reproduce since the original occurrence. I suspect it was cleared by power cycling. Will loop back if this problem resurfaces. ORIGINAL POST: After the firmware to v1.1.8 from v0.7.5 a few weeks ...
- Sun Nov 19, 2023 6:40 pm
- Forum: Wolfmix Owners Forum
- Topic: WTOOLS BUG: Unable to update firmware, sync projects from computer to wolfmix, or do factory reset while in WLINK mode
- Replies: 1
- Views: 2134
WTOOLS BUG: Unable to update firmware, sync projects from computer to wolfmix, or do factory reset while in WLINK mode
I had issues using WTOOLS with one of my two WMX1 controllers. I was unable to update the firmware ("An error occurred reading controller settings") and it would either fail at 17% or 99%. I was also unable to sync projects from the computer to the WMX1, and factory reset also failed. Afte...