Wolfmix

remove the profile from the Wolfmix and reload it new again. That will (eventually) reset the Color map of your fixture

The "issue" with Varytech Hero Spot 140 is normal. This fixture simply has no automatic Off when no Color is selected. Even if no Color is selected, the White beam will remain to be ON. That is how the design of the FIXTURE was made. See the snipped of the manual - its just always OPEN. If...

not without sufficient information: What fixture model (name!) are you using (6ch 2-eye blinder is not very precise)? What profile did you load for it (name)? What is your Live Edit looks like (either describe or do a pic and upload)? (eventually touched Dimmer channel - and accidentially set to 0 w...

use WTOOLS (FIXTURES tab) When your profile has been edited/created on Wolfmix, it will be in the WOLFMIX folder (on Wolfmix Controller side). Click on BACKUP at the bottom to move (re-sync) into your Cloud (Cloud and Computer side). As the profile is now in your Cloud, you can "sync" the ...

ApeLabs fixtures - using CONNECT or WAPP box - are simple 4ch profiles, Red, Green, Blue and White. Then there is also the 7ch mode (only for auto- sound programs) and the 8ch mode, which is 4ch + RGBW fine channels. If not done, please update the CONNECT box and your fixtures to the latest ApeLab f...

because the profile (45ch mode) is not optimized for the Wolfmix operation. It is configured for the 7x RGBW of the individual lenses - separated by beam assignments - but at the same time using RGBW for ALL lenses simultaneous. But it can be only EITHER OR - so the Color channels will block each ot...

you have an "universal" Strobe button for all Wolfmix (ColorFX, BeamFX, static Colors, ...) When pressing Strobe and the light is on, it is simply strobing,...unless a Group is being excluded from Strobe. But no "fancy" Strobe pattern here. If that is not enough you can also use ...

update to the latest firmware (2.0.3)
There was a problem with the first beta loading fixtures which are able to "split" ( doing an immediate Reset)

Even a "split" profile has just ONE single DMX address and the following channels have to be "linked" to meet the total channel mode of the fixture. So when you change the address of a "split" fixture, you can only change the "main" address of the whole fixtur...

It is a problem of Firmware 2.x! The new firmware is (currently) not able to handle the 2 SMOKE channels in a profile. And it is "mixing" the channels (when change the Fan speed, it sends a Haze Intensity value...)